Maintenance And Cleaning; Cleaning The Central Filters, Cleaning The Large Filter, Internal And External Cleaning - Zanussi ZI 609 Instruction Booklet

Table of Contents

Advertisement

MAINTENANCE AND CLEANING

Cleaning the Central Filters
(After each wash)
Inspect the central filters (B) and (C) and remove any
scraps of food with a brush, under running water.
Filters (B) and (C) are both removed by lifting up the
outer one (B) (pulling the central funnel upwards); the
smaller filter (C) can then be removed by pressing the
two tongues (D).
C
D
B
MA13
MA08
Once cleaned, refit the filters by pressing them
down until they click into place.
Cleaning the Large Filter
(Once a month)
Clean the large filter (A) on both sides under running
water, using a brush.
To take it out, remove the spray arm by pressing the two
tongues (E), turn the ring (F) anticlockwise (towards the
left) and then slide the whole part out. Refit the filter
following the above instructions in reverse order.
E
A
F
MA01
Caution: the dishwasher must not be used with-
out filters.
Incorrect repositioning of the filters will produce
poor washing results.
Cleaning of the filters is vital to ensure correct
operation of the machine.
Internal and External Cleaning
You must ensure that the seals around the door, the
detergent and rinse aid dispensers are cleaned
regularly with a damp cloth.
We recommend the use of a Dishwasher Cleaner every
3 months, or run a 65°C wash programme without
dishes using detergent.
Check that the spray arm nozzles are not obstructed.
To remove the bottom spray arm, release it from its
securing catches and pull it out.
To clean the nozzles of the top spray arm, slide out
the top basket whereby the spray arm will become
accessible. To remove it, lift up the WRD and unscrew
the ring nut (see instructions below).
Clean the external surfaces of the machine and
control panel with a soft damp cloth. If necessary use
only neutral detergents. Never use abrasive products,
scouring pads or solvents (acetone, trichloroethylene
etc...).
MA06
Refit the dispenser by following the above instructions
in reverse order.
Fasten it back onto the support by turning it clockwise.
Important: Never use your dishwasher without the
WRD dispenser.
Since WRD also ensures correct distribution of the
water to the upper spray arm, running the dishwasher
without it will impair the washing results.
PMA09GB
32
Check that the Washing
Roto Dispenser (WRD) is not
clogged with detergent
residue. If necessary, rinse it
under running water after
having removed it from
the basket by twisting it
anticlockwise and pulling it
upwards.

Advertisement

Table of Contents
loading

Table of Contents