Messages And How To React To Them - Pioneer AVIC-F220 Operation Manual

Appendix
Appendix

Messages and how to react to them

The following messages may be displayed by your navigation system. Refer to the table below to
identify the problem, then take the suggested corrective action.
There are occasions when you may see error messages other than those shown here. In such a
case, follow the instructions given on the display.
Messages for navigation functions
Message
Route calculation was not
possible.
Route calculation not possi-
ble: destination is too far.
Route calculation not possi-
ble: destination is too close.
Route calculation not possi-
ble: navigation cannot be pro-
vided around destination or
starting point.
Route to destination cannot
be calculated.
Failed to make the route pro-
file.
Application startup failed.
Check file on SD card. Press
"OK" to exit Application
Mode.
64
Engb
When
Route calculation has failed be-
cause of a malfunction in map data,
software, or hardware.
The destination is too far.
The destination is too close.
The destination, waypoint(s), or
starting point are in an area where
no road exists (e.g. a mountain) and
the route calculation is impossible.
The destination or waypoint(s) are in
an isolated island, etc. without a
ferry and the route calculation is im-
possible. If there is no road con-
nected to your starting point or
destination, this message will ap-
pear.
In rare cases, a route calculation
error may occur.
The application is not stored on the
SD memory card.
The application failed to download
properly.
A file required for application start-
up is not stored on the SD memory
card or is damaged.
The SD memory card is damaged.
What to do (Reference)
! Change the destination.
! Consult the Pioneer Local dealer if this mes-
sage persists.
Set a destination closer to the starting point.
Set a destination farther from the starting
point.
! Set a destination and waypoint(s) on roads.
! Reset the destination after you drive the ve-
hicle to any road.
Change the destination.
! Retry.
! Consult the Pioneer Local dealer if this mes-
sage persists.
Use the utility programme navgate FEEDS to
confirm the proper solution.
Use the utility programme navgate FEEDS to
confirm the proper solution.
Use the utility programme navgate FEEDS to
confirm the proper solution.
Make sure there are no problems with the SD
memory card.