Messages And How To React To Them; Messages For Navigation Functions - Pioneer AVIC-HD1BT Operation Manual

MAN-HD1BT-SOFTW-EN.book Page 172 Thursday, April 20, 2006 3:47 PM
Symptom
Dialing is not possible because the
touch keys for dialing is inactive.

Messages and How to React to Them

Messages for navigation functions

The following messages may be displayed by your navigation system.
There are occasions when you may see error messages other than those shown here. In such a
case, follow the instructions given on the display.
Message
Irregular speed pulse signal
detected. Please power off the sys-
tem and check the installation. Then,
please re-boot the system and press
"OK".
Speed pulse not connected. Calibra-
tion will start without speed pulse.
Accuracy is not fully ensured without
speed pulse.
Vibration detected. Please power off
the system and check the installa-
tion. Then, please re-boot the system
and press "OK".
Direction of G sensor is not correct.
Please power off the system and
check the installation. Then, please
re-boot the system and press "OK".
Gyro Sensor is not working properly.
Please consult your dealer or Pioneer
service centre.
Positioning is not possible due to the
hardware. Please contact your dealer
or Pioneer service centre.
GPS antenna problem detected.
Please contact your dealer or Pioneer
service centre.
This function is currently unavailable. The screen cannot be displayed with
172
Cause
Your phone is out of range for serv-
ice.
The connection between mobile
phone and the Bluetooth unit (navi-
gation system) cannot be established
now.
The mobile phone is not registered to
the navigation syetem yet.
When
If the navigation system does not
receive the vehicle speed pulse.
The speed signal input (pink lead
wire) of the power cable is not con-
nected.
The navigation unit is installed in a
place where it may be affected by a
large vibration.
Direction of G sensor is set incor-
rectly.
Abnormal output of Gyrosensor is
detected.
The location display is not possible
due to failure of hardware.
The location display is not possible
due to failure of GPS aerial.
Vehicle Dynamics Display.
Because the sensor has not been
taught so the sensor information
cannot be acquired.
Action (See)
Retry after entering within range for
service.
Perform the connection process.
To use the mobile phone featuring
the Bluetooth wireless technology
with this navigation system, the reg-
istration process is necessary.
What to do
Consult your Pioneer dealer.
To operate with 3D hybrid mode, con-
nect the speed signal input (pink
lead wire) of the power cable cor-
rectly.
Although it can be operated with
Simple hybrid mode without con-
necting the speed signal input, the
precision of the positioning will be
less accurate.
Re-install the navigation unit in a
place where the unit will not be
affected by vibration.
See the Installation Manual and set
the direction of the navigation unit
correctly.
Note down the error code shown on
the screen; turn off the power, and
then contact your nearest Pioneer
service facility.
Consult your dealer.
Consult your dealer.
If the sensor learning status reaches
the Sensor Initialising status or
more, the system is ready to be used.