To comply with FCC rules the ANT24O5 antenna should only be used with devices that have been FCC approved for use with the ANT24O5. Please check the NETGEAR web site at http://www.NETGEAR.com/go/antennas_fcc for an updated list of FCC approved devices.
Figures 1 and 2 show where one could place the ANT24O5 for best coverage in an office. In Figure 1, the ANT24O5 is placed on the ceiling in the middle of the area to cover. In Figure 2, the ANT24O5 is placed in an elevated location on an interior wall, above and facing the Approximate indoor coverage.
After attaching your new antenna, reconnect your wireless device to the network and turn it on. Wireless device with a single antenna NETGEAR antenna cable Wireless Access Point Antenna ETHERNET 5-12V DC...
Specifications The ANT24O5 built-in cable specifications are listed here. ANT24O5, 5 dBi Omni-directional Description 10cm RG318 Description Antenna with a 10cm RG318 cable and RG318 Type reverse female jack SMA connector 10 cm = 3.9 in Length Frequency Range 2450 ± 50MHz 2.5 mm...
Page 6
In the interest of improving internal design, operational function, and/or reliability, NETGEAR reserves the right to make changes to the products described in this document without notice. NETGEAR does not assume any liability that may occur due to the use or application of the product(s) or circuit layout(s) described herein.