Stream Feeding Mode; Exposure Adjustment/Photo Copying - Sharp AR-156 Operation Manual

NORMAL COPYING
When making two-sided copies from the original table, place the second original on
2
the original table and press the print (
G
To cancel two-sided copying after scanning the first original, press the clear
(

Stream feeding mode

The stream feeding mode allows easy operation of continuous copying from the RSPF.
If the stream feeding mode has been enabled using user program No.4, the RSPF ( ) indicator
will blink for approximately 5 seconds after the last original has been fed by the RSPF. While
this indicator is blinking, any new originals placed in the document feeder tray will be fed and
copied automatically. If the stream feeding mode has been disabled, the print (
pressed each time the originals are set even immediately after completion of a copy run from
the RSPF. The default setting of the stream feeding mode is "ON". See page 21, USER
PROGRAMS.

EXPOSURE ADJUSTMENT/PHOTO COPYING

Copy density adjustment is not required for most originals in the automatic exposure mode. To
adjust the copy density manually or to copy photographs, the exposure level can be adjusted in
five steps manually.
Set the original and check the copy paper size.
Press the exposure mode selector key to select the manual (
mode.
Use the light (
If exposure level 2 is selected, the two left-handmost indicators for that level will light
up simultaneously. Also, if level 4 is selected, the two right-handmost indicators for
that level will light up simultaneously.
16
00C-2-156ex.p65
) key.
) and dark ( ) keys to adjust the exposure level.
16
) key.
) mode or photo (
4/11/00, 9:36
) key must be
)