Makita 1902 Instruction Manual page 7

2
3
1
4
5
6
7
1. Inside edge of gauge plate
2. Blade edge
3. Planer blade
4. Adjusting plate
5. Screws
6. Heel
7. Back side of gauge base
8. Gauge plate
9. Gauge base
1. Socket wrench
2. Bolt
1
2
3
4
1. Pan head screw
2. Adjusting plate
3. Planer blade locating lugs
4. Gauge plate
5. Heel of adjusting plate
6. Set plate
7. Inside flank of gauge plate
8. Gauge base
9. Back side of gauge base
10.Mini planer blade
002556
8
9
For tool with mini planer blades
1. Remove the existing blade, if the tool has been in use, carefully clean the
002564
drum surfaces and the drum cover. To remove the blades on the drum,
unscrew the three installation bolts with the socket wrench. The drum
cover comes off together with the blades.
1
2. To install the blades, loosely attach the adjusting plate to the set plate
2
with the pan head screws and set the mini planer blade on the gauge
base so that the cutting edge of the blade is perfectly flush with the inside
flank of the gauge plate.
3. Set the adjusting plate/set plate on the gauge base so that the planer
blade locating lugs on the set plate rest in the mini planer blade groove,
then press in the heel of the adjusting plate flush with the back side of the
gauge base and tighten the pan head screws.
4. It is important that the blade sits flush with the inside flank of the gauge
plate, the planer blade locating lugs sit in the blade groove and the heel
002565
of the adjusting plate is flush with the back side of the gauge base.
Check this alignment carefully to ensure uniform cutting.
5
6
7
8
9
10
7