Step 1: Base Configuration - HP DL385 Quickspecs

QuickSpecs
Configuration Information - Factory Integrated Models
NOTE: This section lists some of the steps required to configure a Factory Integrated Model. To ensure only valid configurations are NOTE: NOTE: NOTE:
ordered, HP recommends the use of an HP approved configurator. Contact your local sales representative for information on CTO
product offerings and requirements.
NOTE: NOTE: NOTE: HP does not allow factory integration of options into standard models listed above. Configure-to-order servers must start NOTE:
with a CTO Chassis.
NOTE: This product offering does not support HP Factory Express Server Configuration Level 1. NOTE: NOTE: NOTE:
NOTE: NOTE: FIO indicates that this option only available as a Factory Installable Option. NOTE: NOTE:

Step 1: Base Configuration

Step 1: Base Configuration
Step 1: Base Configuration Step 1: Base Configuration
Base Models Base Models Base Models Base Models
Step 1A: Add Storage Step 1A: Add Storage
Step 1A: Add Storage Step 1A: Add Storage
Storage Controllers Storage Controllers Storage Controllers Storage Controllers
Step 2: Choose Required Options (only one of the following from each list unless otherwise Step 2: Choose Required Options (only one of the following from each list unless otherwise Step 2: Choose Required Options (only one of the following from each list unless otherwise Step 2: Choose Required Options (only one of the following from each list unless otherwise
noted) noted)
noted) noted)
Processors Processors Processors Processors
Base Memory Base Memory Base Memory Base Memory
Step 3: Choose Additional Factory Integratable Options Step 3: Choose Additional Factory Integratable Options Step 3: Choose Additional Factory Integratable Options Step 3: Choose Additional Factory Integratable Options
Performance Packs Performance Packs Performance Packs Performance Packs
Step 4: Choose Additional Options for Factory Integration Step 4: Choose Additional Options for Factory Integration Step 4: Choose Additional Options for Factory Integration Step 4: Choose Additional Options for Factory Integration
NOTE: For additional options, please refer to the "Options" section below. NOTE: NOTE: NOTE:
HP ProLiant DL385G5 CG CTO Chassis
Ships with: Ships with: Ships with: Ships with:
1 AMD Opteron 2356 (2.3 GHz, 75 Watts)
(8) SFF Serial Attached SCSI (SAS) Drive Bays
Two Embedded NC373i Multifunction Gigabit Server Adapters
PCI-Express Riser Cage
2 x -48VDC power supplies
Hot plug fans (fully redundant)
Rack (2U), (3.5-inch)
HP Smart Array P400/256 DL38x LP FIO Ctr
NOTE: NOTE: NOTE: NOTE: PCI Express.
HP SC44Ge Host Bus Adapter
AMD Opteron Processor 2356 (2.3 GHz, 75 Watts) Kit
NOTE: DIMM banks are active only when the corresponding processor socket is NOTE: NOTE: NOTE:
populated. Choose up to four kits per server.
1 GB PC2-5300 DDR2 (2 x 512 MB) Kit, single rank
2 GB PC2-5300 DDR2 (2 x 1 GB) Kit, single rank
4 GB PC2-5300 DDR2 (2 x 2 GB) Kit, dual rank
8 GB REG PC2-5300 (2 x 4 GB) Kit, dual rank
N/A
DA - 13086 North America — Version 5 — April 3, 2009
HP ProLiant DL385 Generation 5 (G5) Carrier-Grade HP ProLiant DL385 Generation 5 (G5) Carrier-Grade HP ProLiant DL385 Generation 5 (G5) Carrier-Grade HP ProLiant DL385 Generation 5 (G5) Carrier-Grade
Server Server Server Server
AH410A
405160-B21
416096-B21
449774-L21
408850-B21
408851-B21
408853-B21
408854-B21
Page 15