Step 8 Electrical Connection - GE WNCK2050H2WC Installation Instructions Manual

Installation Instructions
STEP 7 COIN BOX MODELS ONLY
ECONOMY WATER USAGE
The pressure switch is set in the foctoru for the high water level
and usage.
To change setting from high water level to medium or low:
WAR ! G
MAKE SUREWASHER IS UNPLUGGEDFROM ELECTRICAL
OUTLET.
o Remove 4 torx screws from back of control panel and lay
control panel front on cover.
! Remove
_Screws
o From the front, move white plastic cam on pressure switch in
the clockwise position with gour finger until it clicks over into
the medium or low water position. (See illustration below).
_ Rotate
kwise
STEP 8 ELECTRICAL CONNECTION
STEP 9 SPECIAL INSTRUCTIONS ON MODELS
WITH SECURITY LOCK CAPABILITY
COVERSECURITYLOCK INSTALLATION
Washer cover is designed to accept stud tgpe lock as shown
below.
Width
Cam Lock Available
From Greenwald
Part #8-1222
To install lock:
, Remove plastic insert in front of coveE
, Install the lock washer on the lock shaft and locate so that
the lock can be engaged in a counterclockwise direction.
, Insert lock mechanism into cover opening and tighten until
snug. (Overtightening mag damage painted surfaces.)
, Install cam and tighten until snug.
ACCESS DOOR LOCK INSTALLATION
To remove the access door retainer before installing a lock,
place the door over a wood block with a 1/2" hole drilled in it
and tap end of screw lightl U with a hammer.
_Nut
_Lock Washer
ill -Spring Washer
_od Nut_"_q[ 'L_Cam
Block
CAUTIO
BEFOREPLUGGINGIN APPLIANCE, READ ELECTRICALAND
PLUMBING REQUIREMENTS AND CHECKLIST.
Plug electrical power cord into a properlg grounded wall
outlet.