GE Monogram ZEU30R Installation Instructions Manual page 7

Electrical Connections
Electronic Radiant Cooktop
Step
1
X_q/en makin,*_ tile wire connections, use tile entire length, of conduit proxided. The conduit must not be
shortened.
Step 2
X4qth the cooktop in place, open the front of the cabinet door.
Step 3
Insert tile wires from tile conduit through tile oi)enim,
of thejtmction box.
Ground.._ Clamp
Step
4
Connect tile red and black leads from tile
cooktop conduit to tile corresi)onding, leads
in thejm_ction box.
ou 2
wire
location
Step
Ouce tile
couuectious aye I/lade, sec/IFe
wires
together using wire UtltS.
Red
/_Strain
_l_Relief
L_ Clamp
Ground/',,1 _ 'Black
GROUNDING INSTRUCTIONS
The bare ground wire in the conduit is cmmected to the cooktop frame. Effective Jmmary 1, 1996, the
National Electrical Code will not permit grounding through neutral If used in new construction after
January 1, 1996 or in a mobile home, recreational vehicle or if local codes do not permit grounding
through the neutral white lead, attach the appliance grounding lead (green or copper) to the residence
grounding conductor (green or bare copper) in accordance with local codes. When cmmecting to a 3
conductor branch circuit, if local codes permit, connect the bare ground cmmector lead of the cooktop to
the branch circuit neutral (gray or white in color).
IMPORTANT: If the cooktop is being installed into a blind counter (one with no cabinet opening below),
wire cmmections must be made before putting the cooktop into the cutout opening.
NOTE: ALUMINUM WIRING
A. WARNING:
IMPROPER CONNECTION OF ALUMINUM HOUSE WIRING TO THE COPPER LI_M)S CAN
RESULT IN A SERIOUS PROBLEM.
B. Spfice copper wires to aluminum wiring using special cmmectors designed mad UL approved for joi_fing
copper to aluminum and follow the manufacturer's recommended connector procedure closely.
NOTE: Wire used, location mid enclosure of splices, etc., must conform to good wiring practice and
local codes.
7