Advertisement
12.Make
Sure Range
is Level.
Level the range by placing a level horizontally
on an oven
rack. Check diagonany from front to back, then level the
range by either adjusting
the leveling legs or by placing
shims under the corners of the range as needed.
13.After
installation
is complete,
make sure all
controls
are left in the OFF position.
Model
and Serial Number
Location
For porcelain
enamel ovens, the serial plate is located on
the right-hand
surface of the oven front frame in the broiler
or storage drawer area.
For continuous
clean ovens,
the serial plate is located on
the right front edge of the floor shield located in the broiler
compartment.
When ordering parts for or making inquires about your
range, always be sure to include the model and serial
numbers and a lot number or letter from the serial plate on
your range.
Your serial plate also tells you the rating of the burners, the
type of fuel and the pressure the range was adjusted for
when it left the factory.
Before You Call for Service
Read the Avoid Service Checklist and operating instructions
in your Owner's Guide. It may save you time and expense.
The list includes common occurrences that are not the
result of defective
workmanship
or materials
in this
appliance.
Refer to the warranty in your Owner's Guide for our toll-free
service number and address. Please call or write if you have
inquiries about your range product and/or need to order
parts.
Care, Cleaning and Maintenance
Refer to the Owner's Guide for cleaning instructions.
If
removing
the
range
is necessary
for
cleaning
or
maintenance,
shut off gas supply.
Disconnect
the gas and
electrical
supply. Ifthe gas or electrical supply is inaccessible,
lift the unit slightly
at the front
and pull out away from the
wall. Pull only as far as necessary to disconnect
the gas and
electrical
supply.
Finish removing
the unit for servicing
and
cleaning.
Reinstall in reverse order making sureto
level the
range and check gas connections
for leaks. See page 3,
step 1 for proper
anchoring
instructions.
Optional
Spice Rack
Some models are equipped
with an optional
spice rack.
Follow the instructions below for installation:
a.
Using a 1/4" nutdriver
or Phillips screwdriver, remove
four (4) screws from rear of range as shown in diagram
below.
b.
Using these four (4) screws, attach
two (2) support
posts (provided)
to rear of range.
c.
Set rack on support
posts and make sure rear end
flanges are around support posts as shown.
Suppo_ posts
pro_dedwith
spicerack
8
Advertisement
