Important Safety Instructions; Installation - Tripp Lite ISOBAR12ULTRA Owner's Manual

Important Safety Instructions

IMPORTANT SAFETY INSTRUCTIONS. This manual contains information concerning the proper
installation and use of Tripp Lite's Rackmount Power Strips and Isobar Surge Suppressors. SAVE
THESE INSTRUCTIONS.
The Surge Suppressor features an internal protection that will disconnect the surge-protective
component at the end of its useful life but will maintain power to the load—now unprotected.
(IBAR12, ISOBAR12ULTRA, RS-1215, RS-1215-RA, RS-1215-HG, DRS-1215):
DO NOT exceed the MAXIMUM LOAD of 15 amps that can be drawn from each
AC outlet. DO NOT exceed the MAXIMUM LOAD of 15 amps that can be drawn
from all the outlets combined.
(IBAR12/20ULTRA, IBAR12-20T, RS-1215-20): DO NOT exceed the MAXIMUM LOAD of 15
amps that can be drawn from each AC outlet located on the front of the IBAR12/20ULTRA
and IBAR12-20T. DO NOT exceed the MAXIMUM LOAD of 20 amps that can be drawn from
each AC outlet on the RS-1215-20, or each AC outlet located on the rear of the
IBAR12/20ULTRA and IBAR12-20T. DO NOT exceed the MAXIMUM LOAD of 20 amps that can
be drawn from all the outlets combined.
Use of this equipment in life support applications where failure of this equipment can
reasonably be expected to cause the failure of the life support equipment or to significantly
affect its safety or effectiveness is not recommended. Do not use this equipment in the
presence of a flammable anesthetic mixture with air, oxygen or nitrous oxide.

Installation

Rackmount Installation
To Mount Unit in Rack:
rackmount screws (A) through the unit's mounting ears
(B) and into the rack rails as shown. The user must
determine the fitness of the rackmount screws to hold the
unit in the rack before installation.
Wallmount/Under Counter
Installation
1. Detach Mounting Ears:
holding the unit's mounting ears (B) to the sides of
the unit.
2. Reorient Mounting Ears:
Step 1 (A) to reattach the mounting ears (B) to the
unit as shown. Use only the manufacturer-supplied
screws or their equivalent (#6-32, ¼" flat head) to
reattach the mounting ears. The screws should be
put through diagonally opposite holes on the ear.
3. Mount Unit on Surface:
screws (C) or similar mounting hardware through the
unit's mounting ears (B) and into the mounting
surface as shown. The user must determine the
fitness of the user-supplied mounting hardware to
support the unit before mounting.
201101193 933089.indd 2
Put four user-supplied
Unscrew the screws (A)
Use the screws from
Put four user-supplied
2
Step 1
Steps 2 & 3
2/21/2011 4:56:18 PM