Cab-1 Remote Controller Numeric Keypad Commands - GE VISION Line ES44AC Owner's Manual

TrainMaster Command Control operations

CAB-1 Remote Controller numeric keypad commands

W
hen you press the AUX1 button on your CAB-1 Remote Controller, you turn the numeric
keypad into ten command buttons. These commands are specific to your locomotive. After
you press the AUX1 button, you will be able to press any numbered button until you address a
different Command Control equipped product. The corresponding LEGACY RailSounds sound
system effects are in bold italic type.
Stops and resets the locomotive. Resets the locomotive's direction to forward. Horn blows.
RPM sounds return to automatic.
Raises the volume of the LEGACY RailSounds sound system background sounds, such as
RPM sounds and let-off sounds. The horn, bell and dialog are unaffected. The default is
full volume. The volume setting is retained when track power is turned off.
Sound volume increases.
Engineer begins radio dialog, dispatcher replies (see page 26).
CrewTalk communication.
Enters manual RPM mode and increases the RailSounds sound system RPM level (see
page 18). If the LEGACY RailSounds sound system is shut down (see 5 key below),
AUX1, 3 activates a full LEGACY RailSounds sound system start-up while the
locomotive is stopped after pressing AUX1, 5 with track power on.
Lowers the volume of the LEGACY RailSounds sound system background sounds, such
as RPM sounds and let-off sounds. The horn, bell, and dialog are unaffected. The
volume setting is retained when track power is turned off. Sound volume decreases.
Activates the LEGACY RailSounds sound system shutdown sequence when stopped.
Activates the emergency stop feature while in motion. Note that in the shutdown
sequence, the smoke unit does not turn off if it was already on. To turn off the smoke
unit, press AUX1, 8 or use the smoke unit SMK/NO SMK switch.
Enters manual RPM mode and lowers the LEGACY RailSounds diesel motor RPM level
(see page 18).
Dispatcher begins radio dialog and engineer replies (see page 19).
TowerCom announcement.
Turns off the smoke unit.
Air release sound.
Turns on the smoke unit if the smoke unit switch is in the SMK position. Be sure to add
smoke fluid before turning on the smoke unit to prevent damage to your locomotive.
Diesel generator blow-off sound.
AUX1, 8 and 9 function only if the locomotive's smoke unit switch is in the SMK
Note!
position. Sounds will be active in both switch positions.
6-28306 Hybrid.indd 25
25
12/16/09 2:57 PM