Grizzly G0641 Owner's Manual page 30

Manual lubrication is required for: 1) blade arbor
housings, 2) tie-rod pivot points, and 3) the upper
pivot point of the main pneumatic ram.
To lubricate the blade arbor housings:
1. DISCONNECT SAW FROM POWER!
2.
DISCONNECT SAW FROM AIR SUPPLY!
3.
Raise the front guard up, remove the inner
blade guard and blades to access the pivot
arm assemblies (see Figure 36).
Blade Arbor Housing
Figure 36. Blade arbor housing grease fitting
(left side shown).
4.
Clean off the arbor grease fittings, then use a
grease gun to add one or two pumps of multi-
purpose grease to the arbor housing grease
fittings.
5.
Re-install the inner blade guard and blades,
then lower and secure the front guard before
continuing operation.
NOTICE
Adding more than one or two pumps to the
arbor housing may cause damage to the
seals and require replacement.
To lubricate the tie-rod pivot points:
1.
DISCONNECT SAW FROM POWER!
2. DISCONNECT SAW FROM AIR SUPPLY!
-28-
Grease Fitting
3.
Raise the front guard up, and remove the
inner blade guard and blades to access the
tie-rods (see Figure 37).
Figure 37. Tie-rod pivot points (one side shown).
4. Brush a small amount of multi-purpose grease
on and around the tie-rod pivot points.
5.
Re-install the inner blade guard and blades,
then lower and secure the front guard before
continuing operation.
To lubricate the main ram pivot point:
1.
DISCONNECT SAW FROM POWER!
2.
Remove the rear cabinet access panel.
3.
Brush a small amount of multi-purpose grease
on and around the main ram pivot point (see
Figure 38).
Main Ram
Pivot Point
Figure 38. Main pneumatic ram pivot point
(shown through the rear cabinet access).
Pivot
Points
G0641 Double Miter Saw