Table of Contents
Advertisement
Bit Installation
Router bits are very sharp. Use care in
handling to prevent injury.
Always use bits that are rated for 20,000
R.P.M. or higher. Do not use bits that are
designed for slow R.P.M. operation. If you
do not know the maximum rated R.P.M. for
a particular bit, do not use it in the overarm
router. The bit could break apart under the
high centrifical forces, causing flying metal
to be launched into the air like a bullet.
Serious personal injury or death could
result.
The Model G8030 Overarm Router uses standard
router bits.
1. Place the proper collet on the spindle. You can
use
1
⁄
" or
1
⁄
" size.
4
2
2. Install the nut loosely as shown in Figure 7.
Figure 7. Installing collet nut.
G8030 3 H.P. Overarm Router
3. Slide the base of the router bit into the collet as
shown in Figure 8.
4. Finger tighten the nut, keeping a grip on the bit.
Figure 8. Installing the router bit.
-13-
Advertisement
Table of Contents
