Disabling / Enabling Time Periods - Honeywell Y9120H Sundial RF2 Pack 1 User Manual

PROGRAMMING YOUR ST9120C
Exiting Programming Mode:
To exit programming mode, move the slider to the RUN position. This can be done at
any time during the programming process, and any changes made and confirmed
with the button will have been saved.
Note: If the unit is left in Programming mode for more than 10 minutes without the slider
being moved or any buttons pressed, the message 'MOVE SLIDER' will be displayed.
Press a button to finish programming, or move the slider to the RUN position.

Disabling / Enabling Time Periods

To disable any of the time periods ON 1 to OFF 1, ON 2 to OFF 2, or ON 3 to OFF 3,
simply set the ON time and its paired OFF time to the same time, and the programme
will just ignore them.
To re-enable the time period, simply set the two ON and OFF times to be different.
11