Configuring The Bridge Mode; Preparation - Huawei EchoLife HG520s User Manual

Service Mode
Note:
ISP = Internet Service Provider
IPoA = Internet Protocol over ATM
Caution:
Some parameters are validated only after they are saved and the
HG520s is rebooted. Follow the prompt in the configuration page to
perform this operation.

3.3 Configuring the Bridge Mode

In the bridge mode, the HG520s serves as a bridge. You need to
install the Point to Point Protocol (PPP) dial-up software to realize the
dial-up access to the Internet.
This section describes the process to configure the HG520s to
work in the bridge mode and the process to configure your computer to
access the Internet through the HG520s.

3.3.1 Preparation

Table 3-2 shows the configuration for the bridge mode.
Name
PVC mode
Encapsulation
VPI/VCI
Multiplex
Working Method
Table 3-2 Configuration for the bridge mode
Configuration
Bridge
RFC2684
Provided by the ISP
Provided by the ISP
14
Configuration