Oil Dipstick; Oil Drain - Husqvarna SG 13 B Operator's Manual

Oil Dipstick

The dipstick for the crankcase oil reservoir is located
on the front of the engine. Refill the engine oil in the
hole where the dipstick fits.
When checking the oil level, the dipstick should not
be screwed in. The machine should be parked on
even ground with the engine stopped. Never run the
engine without the dipstick in place. The engine has
an electronic oil level guard. It stops and cannot be
started if the level becomes too low. Yet you should
not rely entirely on the level guard; rather you should
check the oil using the dipstick.
For normal use, SAE 10W-30 weight engine oil service
SF-SG is recommended; see also Lubrication.

Oil Drain

The drainage screw for the crankcase oil reservoir is
located on the back of the engine.
IMPORTANT INFORMATION
Used engine oil is a health hazard and
legislation prohibits disposal on the ground
or in nature; it should always be disposed
of at a workshop or appropriate disposal
location. Avoid skin contact; wash with soap
and water in case of spills.
22 -
HUSQVARNA
CONTROLS
8011-020
8011-187