Table of Contents
Advertisement
Chapter 3 Setup
Advanced DHCP Settings (Advanced View)
Complete the following steps to configure the Local Network DHCP Settings
available from the Advanced View:
1
Navigate to the Advanced DHCP Settings.
Path: Setup > Local Network > Advanced View
2
Select the desired option for the the DHCP Address, which defines the DHCP
address allocation method:
Use DHCP Pool—This option assigns local IP addresses from the DHCP
pool you have defined. This is the default option for this parameter. Skip to
step 5.
Use WAN Subnet—Select this option to have the local network devices share
the WAN subnet address. In this pass-through mode, the local computers get
WAN-side IP addresses. They bypass NAT and are visible on the service
provider's network. However, these computers can still communicate with
other computers that are allocated private IP addresses. Continue with step 3.
Share WAN IP—Select this option to have a local network device share the
WAN IP address. In this mode, which is also known as super-DMZ mode, a
single computer bypasses NAT. You can specify the computer's MAC
address in the MAC Address field. Continue with step 3.
3
If you selected Use WAN Subnet or Share WAN IP, select the appropriate WAN
IP connection to use from the WAN IP Interface drop-down menu.
4
If you selected Share WAN IP, enter the MAC address of the local network
device in the MAC Address field.
5
In the Lease Time field, enter the number of seconds you want the local network
device to lease the WAN IP address.
6
Click Save Settings to apply your changes, or click Cancel Changes to cancel
your changes.
40
3425-00669 Rev E
Advertisement
Table of Contents
