Chapter 3 Setup - Cisco WAG310G User Manual

Residential gateway with voip
Hide thumbs Also See for WAG310G:
Table of Contents

Advertisement

3425-00669 Rev E
3
Chapter 3
Setup
Introduction
This chapter provides information for using the web-based utility to
configure ADSL, Ethernet, and Local Network connections.
You can access the utility via a web browser on a computer connected
to the residential gateway.
The web-based utility has these main tabs: Setup, Wireless, Voice,
Storage, Security, Access Restrictions, Applications & Gaming,
Administration, and Status. Additional tabs will be available after you
click one of the main tabs.
This chapter focuses on the configuring the parameters that are
accessed via the Setup tab.
Important: The web-based utility pages and the examples shown in
this section are for illustration purposes only. Your pages may differ
from the pages shown in this guide. The pages shown in this guide
also represent the default values for the device.
Notes:
If you are not familiar with the network configuration procedures
detailed in this section, contact your service provider before you
attempt to change any of the residential gateway default settings.
If your service provider supplied you with the residential gateway,
then it may be pre-configured for you, and you will not need to
make any changes. Contact your service provider for more
information.
For New Zealand residents, refer to the note under PPPoA (RFC
2364).
15

Advertisement

Table of Contents
loading

Table of Contents