Electrical Connection - Electrolux EUT1106AOW User Manual

14 www.electrolux.com
If the ambient temperature is cold (i.e. in
Winter), the gasket may not fit perfectly to
the cabinet. In that case, wait for the nat-
ural fitting of the gasket.
In case you do not want to carry out the
above mentioned operations, contact the
nearest After Sales Service Force. The Af-
ter Sales Service specialist will carry out
the reversibility of the doors at your cost.

9.5 Electrical Connection

CAUTION!
Any electrical work required to in-
stall this appliance should be car-
ried out by a qualified electrician
or competent person.
WARNING!
This appliance must be earthed.
The manufacturer declines any lia-
bility should these safety meas-
ures not be observed.
1
2
• Refit the upper hinge pin into the oppo-
site location.
• Fit the door in place on the hinge pin.
• Slot the hinge pin into the hole in the
hinge plate and relocate the hinge as-
sembly to the opposite location and re-
fit using the retaining screws.
• Refit the bottom hinge plate assembly
on the opposite side, taking care that
the edge of the door is parallel with the
side of the cabinet.
• Remove and install the handle (if fore-
seen)on the opposite side.
• Reposition, level the appliance, wait for
at least four hours and then connect it
to the power socket.
Do a final check to make sure that:
• All screws are tightened.
• The door opens and closes correctly.