Table of Contents
Advertisement
• Fix the sides of the
cooker hood by
fastening the pins
(10a) to the sides of
the fastening screws
(10b).
• Block the sides
sliding the two tabs
outwards (11).
• Make electrical
connection (12), but
leave the hood
disconnected from the
home mains circuit.
• In the case that it is decided to use the cooker hood in the mains
circuit, then place one of the two flanges provided in the exit hole (13
– Extraction).
Attention! The tall flange should be used when a telescopic
chimney is required to be mounted (this item should be ordered –
see special accessories), the short flange is to be used in all other
cases.
• Remount the grease filter and the front panels according to the
numbering noted also on
the back of each screen
(from 1 to 4 from the top to
the bottom).
• Connect the hood to the
home mains circuit and
check if the hood works
properly.
Fig. 10
Fig. 11
Extract. version
Recirc. vers.
17
Advertisement
Table of Contents
