Charcoal Filter - Electrolux DD 8795 User Manual

Charcoal filter

• The charcoal filter should only be used if you want to use the hood
in the recirculation function.
• To do this you will need an original charcoal filter (available from
your local Service Centre).
• Cleaning/replacing the charcoal filter
Unlike other charcoal filters, the LONGLIFE charcoal filter can be
cleaned and reactivated. With normal use the filter should be
cleaned every second month (when using the hood 2,5 hours per
day,on avarage). The best way to clean the filter is in the
dishwasher. Use normal detergent and choose the highest tempera-
ture (65º C). Wash the filter separately so that no food parts gets
stuck on the filter and later causes bad odours. To reactivate the
charcoal, the filter should be dried in an oven for 10 minutes with a
maximum temperature of 100º C.
After approximately three years of use, the charcoal filter should be
replaced with a new, as the odour reduction capacity will be
reduced.
• Fitting
Fit the charcoal filter on the rear
side of the grease filter, fix it with
two metal wires. Fig. 6.
Attention! The metal wires are
included in the carbon
filter packing and not on the
hood
• To remove proceed in the
reverse order.
• Always specify the hood model
code number and serial number
when ordering replacement
filters. This information is shown
on the registration plate located
on the inside of the unit.
• The charcoal filter can be
ordered from your local Service
Centre.
charcoal filter
metal wires
Fig. 6 grease filter
11