Operation Of Lcd Panel; Preparation Of Craft Paper/Fabric - Brother 891-Z01 Operation Manual

c
Press in the operation panel.
When the opening screen appears, touch anywhere on
the display.
When the following message appears, touch the
"OK" key.
The home screen appears.
Memo
• LCD panels commonly have bright spots
(permanently lit dots) and dark spots (unlit
dots). It may cause some unexpected luminous
spots to appear and tiny picture elements to be
missed in the screen. Please note that this is
not a sign of malfunction.
d
To turn off the machine, press
operation panel.
e
Disconnect the power cord from the AC
adapter, and then disconnect the AC adapter
from the machine.
Note
• Do not wind the AC adapter cable around the
adapter or bend the cable, otherwise the cable
may be damaged.

Operation of LCD Panel

After the machine is turned on, the operation screens
appear in the touch panel. To perform operations in
the screens, use the included touch pen.
• Never use a hard or pointed object, such as a

Preparation of Craft Paper/Fabric

Prepare the material for cutting, drawing and
scanning (Direct Cut), based on the following
conditions.
Required
Material
Condition
Thickness*
in the
* Recommended thickness varies depending on the
type of material used.
• Avoid using craft paper or fabric covered with
• When using an optional 12" × 24" (305 mm ×
• Some fabrics with uneven surfaces can be cut if
Note
mechanical pencil or screwdriver, to make a
selection in the screens. Otherwise, damage to
the machine may result.
Paper
(When using a 12" × 12" (305 mm ×
305 mm) mat.)
Size Max: 305 mm × 305 mm (12" × 12")
The work area for cutting/drawing is
296 mm × 298 mm (11 3/4" × 11 3/4").
0.1 mm to 0.3 mm 0.2 mm to 1.5 mm
scrapbook paper,
Type
cardstock, vellum
Note
decorative layer (that can easily separate), such
as lamé or foil. The separate layer may stick to
the machine's scanning device or feed rollers
during operation, resulting in damage to the
machine. It may also damage the cutting blade.
If such media is used or tested it is
recommended to clean the scanner glass at the
bottom of the machine after every use
(page 59).
Memo
610 mm) mat, the maximum work area for
cutting/drawing is 296 mm × 603 mm (11 3/4" ×
23 3/4").
turned upside down.
1
Fabric
cotton fabric, felt
11