Related Manuals for GE Wine Chiller Wine Reserve and Beverage Center
Summary of Contents for GE Wine Chiller Wine Reserve and Beverage Center
-
Page 1: Installation Instructions
Installation Instructions If you have questions, call 800.626.2000 or visit our website at: www.monogram.com Wine Chiller, Wine Reserve Beverage Center Design Guide With Installation Instructions... -
Page 2: Table Of Contents
BEFORE YOU BEGIN: Read these instructions completely and carefully. IMPORTANT – Save these instructions for local inspector’s use. IMPORTANT – Observe all governing codes and ordinances. Note to Installer – Be sure to leave these instructions with the Consumer. Note to Consumer –... -
Page 3: The Installation Space
THE INSTALLATION SPACE Locate Outlet 10-1/2" 24" 9" Max. 34-1/2"-35" 1-1/2" 23-3/4" Min. NOTE: Handle and handle standoff depth is 1-3/4″ The cutout depth should be 24″ The cutout dimensions shown allow for a full door swing and access to the pull-out racks when installed as a built-in in standard 24″... -
Page 4: Tools, Hardware
TOOLS REQUIRED • #2 Phillips screwdriver • Adjustable wrench PARTS SUPPLIED • Monogram nameplate • Hardware for changing door swing • Optional stainless steel toekick with screws and spacers • Left and right side hinge covers • Top screw hole cover GROUNDING THE WINE CHILLER, WINE RESERVE AND BEVERAGE CENTER... -
Page 5: Step 2, Reverse Door Swing
Installation Instructions STEP 2 REVERSE DOOR SWING SKIP THIS STEP IF DOOR SWING SUITS THE INSTALLATION Parts Included: • Top left case hinge • Bottom left case hinge • Left and right side decorative hinge cover • Decorative hinge screw hole cover ®... -
Page 6: Step 3, Leveling
Installation Instructions STEP 3 LEVEL • Use an adjustable wrench to turn the leveling legs and raise or lower the product. • Adjust carefully; the product should be level and plumb with cabinetry, and should align with adjacent toekick height. Turn Right to Lower Turn Left to Raise If you skipped Step 2:... -
Page 8: Template For Nameplate
TEMPLATE FOR NAMEPLATE LOCATION Upper Left Corner of Glass if Hinge is on Left Door Frame Side To position nameplate: • Cut template along dotted line. • Hold or tape template behind glass door so that it is visible from the front side.