Tools And Materials Required; Power Supply - GE Monogram ZV850 Installation Instructions Manual

• Tape measure
Tools and
• Knife
Materials • Spirit level
• Wire cutter
Required
• Wire stripper
• Wire nuts
(not supplied)
• Electric drill and 5/32" bit
• Phillips screwdriver
• Flat blade screwdriver
• Hammer
• Pliers
• 10 mm Hex wrench/socket
• Safety glasses
• Tape to mount template
• Gloves to protect against sharp edges
IMPORTANT - (Please read carefully)
Power
Supply
Electrical supply
This vent hood must be supplied with 120V,
60Hz, and connected to an individual, prop-
erly grounded branch circuit, and protected
by a 15 or 20 amp circuit breaker or time delay
fuse.
• Wiring must be 2 wire with ground.
• If the electrical supply does not meet the
above requirements, call a licensed electrician
before proceeding.
• Route house wiring in the ceiling, as close to
the installation location as possible.
Allow an additional 3 feet length from ceiling
joists to reach the junction box on the hood.
• Connect the wiring to the house wiring in
accordance with local codes.
4
CAUTION
WARNING
FOR PERSONAL SAFETY, THIS
APPLIANCE MUST BE PROPERLY
GROUNDED.
Remove house fuse or open circuit
breaker before beginning
installation.
Do not use an extension cord or adapter
plug with this appliance. Follow National
electrical codes or prevailing local codes and
ordinances.
Installation Preparation
36" Island Vent Hood
• 120V 60Hz. 15 or 20 Amp, 2 wire with ground. Properly
grounded branch circuit.
• Strain relief for junction box cover.
• Plumb
• Center punch
Grounding Instructions
The grounding conductor must be connected
to a ground metal, permanent wiring system,
or an equipment-grounding terminal or lead
on the hood.
CAUTION
WARNING
Warning: The improper connec-
tion of the equipment-grounding
conductor can result in a risk of
electric shock. Check with a
qualified electrician or service
representative if you are in doubt whether
the appliance is properly grounded.