Honeywell Gamewell 7100 Series Installation & Operating Manual page 41

Main
Walk/Drill
Main
I/O
Main
I/O
Select
Output On/Off
Main
I/O
Select
Enable/Disable
9000-0447 Rev. I
[Walk/] 1: Drill
[DRILL] 3: Silent Test (OFF)
1: Toggles Fire Drill ON/OFF.
2: Toggles Audible Walk Test ON/OFF.
3: Toggles Silent Walk Test ON/OFF.
[I/O ] 1: Output On/Off
[CTRL] 2: Enable/Disable Device
1: Opens Select Device to Control Menu.
2: Opens Select Device to Enable Menu.
Note: These are the same menus as used in the Configure section,
or similar, except after selection they proceed to the following menus.
[CNTRL] NAC 1
[L,AAA ] 1:On/Auto
1: Toggles selected output ON/AUTO.
Output selections include NAC1, NAC2, and Muni Circuit (if present).
These appear at the bottom of the output device scroll list, and can
be entered by keypad as addresses 0001, 0002, and 0003.
(Note that AOMs start at address 1101). If the selected device is an
AOM, its location is shown, otherwise NAC 1, NAC2, or Municipal
Circuit. Status LEDs and relays are not considered to be
programmable outputs.
[ENA/DIS] Municipal Circuit (ENABLED)
[L,AAA ] 1: Enable/Disable
1: Toggles selected device ENABLED/DISABLED
Page 35 of 42
(OFF) 2:Audble Test (OFF)
(AUTO)