Site Requirements - Cisco 1240 Hardware Installation Manual

Chapter 2 Installation Safety and Site Preparation
In order to comply with FCC radio frequency (RF) exposure limits, antennas for this product should be
Warning
located a minimum of 7.9 in. (20 cm) or more from the body of all persons. Statement 332
Do not operate the unit near unshielded blasting caps or in an explosive environment unless the
Warning
device has been modified to be especially qualified for such use. Statement 364
This equipment must be externally grounded using a customer-supplied ground wire before power is
Warning
applied. Contact the appropriate electrical inspection authority or an electrician if you are uncertain
that suitable grounding is available. Statement 366
Warning Do not work on the system or connect or disconnect cables during periods of lightning activity.
Statement 1001
Warning Read the installation instructions before connecting the system to the power source. Statement 1004
This product relies on the building's installation for short-circuit (overcurrent) protection. Ensure that
Warning
the protective device is rated not greater than 20 A. Statement 1005
This unit is intended for installation in restricted access areas. A restricted access area can be
Warning
accessed only through the use of a special tool, lock and key, or other means of security.
Statement 1017
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Warning
Statement 1030
Warning Ultimate disposal of this product should be handled according to all national laws and regulations.
Statement 1040
Warning Installation of the equipment must comply with local and national electric codes. Statement 1074

Site Requirements

This section describes the requirements your site must meet for safe installation and operation of your
router. Ensure that the site is properly prepared before beginning installation. If you are experiencing
shutdowns or unusually high errors with your existing equipment, this section can also help you isolate
the cause of failures and prevent future problems.
OL-26223-04
Cisco 1240 Connected Grid Router Hardware Installation Guide
Site Requirements
2-3