Care And Cleaning - GE RANGES JSP26 Owner's Manual

Care and cleaning of the range.
Be sure electrical power is off and all surfaces are cool before cleaning any part of the range.
If your range is removed for cleaning, servicing or any reason, be sure the anti-tip
device is re-engaged properly when the range is replaced. Failure to take this
precaution could result in tipping of the range and cause injurjz
How to Remove Packaging Tape
To assure no damage is (tone to tim finish
of the pro&lct, dm safest way to remove
the adhesive left from packaging tape on
new appliances is an application of a
household liquid dishwashing detergent,
mineral oil or cooking oil.
Apply widl a soft clot1 and allow to soak.
Wipe dU and then apply an appliance
polish to thoroughly clean and protect
the surf>me.
NOTE:Theplastictapemustbe removed fromall
chrome trim.It cannot b e removed if it isbakedon.
Control Panel
It's a good idea to wipe dm control panel
after each use. Clean wid_ mild soap and
water or vinegar and water, rinse with
clean water and polish dry with a sof_
cloth.
Do not use abrasive cleansers, strong
liquid cleansers, plastic scouring pads or
oven cleansers on the control panel-they
will damage the finish. A 50/50 solution
of vinegar and hot water works well.
Moldedfib
Control Knobs
Thecontrol k nobsmaybe removed foreasier
cleaning.
Before relnoving file knobs for cleaning,
please note fllat tim knobs are in tim OFF
position. When replacing the knobs,
check the OFFposition to insure proper
placement.
The knob stein has a groove in each side.
The _'oove on one side has a spring clip.
The odler groove is clear (see
illustration). Check the inside of the knob
and find the molded rib.
Wash file knobs in soap and water or a
x4negar and hot water solution but do
not soak.
Replace the knob by fitting fl_e molded
rib inside the knob into the clear groove
on the stein.
Oven Vent
(glass eooktopmodels only)
On models with glass cooktops, fl_e oven
is vented fl_rough an opening at file rear
of the cooktop.
Nevercovertheopening with aluminum foil or
anyothermaterial
Oven Vent (electriccoilmodelsonly)
The oven is vented fllrough an opening
under the right rear surf_tce unit.
Nevercovertheopening with aluminum foil or
anyothermaterial
22