B Regulatory Compliance And Safety; Regulatory Compliance Notices; Federal Communications Commission Notice For Class A Equipment; Declaration Of Conformity For Products Marked With The Fcc Logo, United States Only - Cisco MDS 8/12c User Manual

B Regulatory Compliance and Safety

Regulatory compliance notices

Federal Communications Commission notice for Class A equipment

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications. Operation of this equipment
in a residential area is likely to cause harmful interference, in which case the user will be required to
correct the interference at his own expense. The end user of this product should be aware that any
changes or modifications made to this equipment without the approval of Hewlett-Packard could result in
the product not meeting the Class A limits, in which case the FCC could void the user's authority to
operate the equipment.
Declaration of conformity for products marked with the FCC logo, United States
only
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
For questions regarding your product, see:
http://www.hp.com
For questions regarding this FCC declaration, contact us by mail or telephone:
Hewlett-Packard Company
P.O. Box 692000, Mailstop 510101
Houston, TX 77269–2000
1–281–514–3333
To identify this product, find the part, Regulatory Model Number, or product number located on the
product.

Modifications

The FCC requires the user to be notified that any changes or modifications made to this device that are
not expressly approved by Hewlett-Packard Company may void the user's authority to operate the
equipment.

Cables

Connections to this device must be made with shielded cables with metallic RFI/EMI connector hoods in
order to maintain compliance with FCC Rules and Regulations.

Regulatory compliance identification numbers

For the purpose of regulatory compliance certifications and identification, your product has been
assigned a unique Regulatory Model Number (RMN). You can find the RMN on the product nameplate
label, along with all required approval markings and information. When requesting compliance
information for this product, always refer to this RMN, which should not be confused with the marketing
name or model number of the product.
The Regulatory Model Number for the switch is:
HSTNS- 1 B10
Cisco MDS 8Gb Fabric Switch for HP BladeSystem c-Class User Guide 33