Wpa Or Wpa2 Wireless Security - NETGEAR CG3000 User Manual

Select Setup > Wireless Settings to display this screen.
2.
Specify the Wireless Network settings.
3.
Name (SSID). The name of the wireless network.
•
802.11 Mode.This is set to Up to 11 b/g/n by default.
•
Bandwidth. The rate of data transfer.
•
SIdeband for Control Channel (40Mhz only). Sideband is a band of frequencies
•
that is either lower or higher than the carrier frequency. You would adjust this setting if
you want to refine the gateway's use of electrical power and bandwidth.
Control channel. Which operating channel is used. Normally, the channel is not
•
changed unless there are interference problems with a nearby access point. The
available channels depend on the region. Some countries have laws specifying which
channels can be used.
For help with Security Options, see the following sections
4.
If you made changes, click Apply so that they take effect.
5.

WPA or WPA2 Wireless Security

By default the gateway is set up to work with both WPA and WPA2 wireless security. (This
security option is already selected.) You can specify the Network Key, which works like a
password to access the wireless network.
NETGEAR Wireless Cable Gateway CG3000
Wireless Configuration
13