Placement Of The Control Center; Creating A Personal Security Code; Quick Reference Card - GE 45129 User Manual

Bypass – You can bypass a Zone so that any Sensors
in that Zone (1, 2, and/or 3) will not trigger the alarm
regardless of HOME or AWAY setting.

Quick Reference Card

The Control Center comes with a quick reference card
and clear storage envelope. Attach the clear envelope
using the peel off adhesive and press it to the bottom
of the Control Center. Use a pencil to indicate where
Sensors are located around your home. On the reverse
side of the card are brief instructions for Arming/
Disarming the system and assigning a Sensor to a Zone.
Lets get started...
Use the following tips to select an ideal location
Position it...
- in a central location of the home, within a few feet of
an electrical outlet.
- some place accessible and easily noticed.
- Away from doors and windows where it could be
easily noticed by intruders.
- Away from heat sources such as an oven, stove
or vents.
- Away from large metal objects (such as refrigerators,
microwaves, etc.) which could effect the
wireless performance.
After you have selected a location for the Control
Center, you are ready to set up your system.
) Plug in the AC adapter to a nearby electrical outlet
and plug the other end into the "Input DC12V" jack
on the side of the unit. All the LED indicators on the
front of the unit will light up briefly and go out. This
indicates the Control Center has completed a brief
system check. Only the green power LED indicator
should remain on.
) Place the Control Center in the selected location
and rotate the antenna to the upright position for
best reception. The Control Center should be able to
receive signals from Sensors and Accessories up to
150 feet away.

Creating a Personal Security Code

The Security Code is used to arm and disarm the alarm
system. The Control Center comes with a factory
default Security Code setting of "1 2 3 4".
It is recommended to establish your own Personal
Security Code. To change the Security Code, locate the
Learn button on the side and Arm button on top.
To create a new Security Code
Step 2
Enter the current code
Step 3
Enter new code
Step 4
Re- Enter new
code to confirm
1 2 3 4
1 2 3 4
Zone
Note:
- When setting the Security Code you have 15 seconds to
begin making the change. After 15 seconds the unit will time
out and return to stand-by mode. If this happens you will
need to start over.
8
Input DC 12V
Step 1
-
+
Mute Press and hold
the Learn button,
Learn
Then press and
hold the Arm
Arm
Alert button together
Chime
for three seconds
Armed Power Off