Dell PowerEdge UCS-71 User Manual page 15

7 Tighten the bracket screw, if any, or use the system's retention clips to
secure the controller to the system's chassis.
8 For the Internal Tape Adapter card, connect the cables from the end
devices to the controller. See Figure 3-2.
NOTE:
Although the Internal Tape Adapter has two internal connectors, only one
internal tape device is supported. Use the connector (on the card) labeled 'A'.
Figure 3-2. Connecting the Cable for the Internal Tape Adapter
1
2
1
cable
3
Internal Tape Adapter
9 For the 6 Gbps SAS HBA controller, connect the cable from the external
tape device or enclosure to the adapter. See Figure 3-3.
NOTE:
external connectors.
The external cable can be connected to either of the two
2
SAS x4 internal connector
Hardware Installation
3
15