GE JKP90SP Dimensions And Installation Information

JKP90SP
GE 27" Built-In Double Microwave/Thermal Wall Oven
®
Dimensions and Installation Information (in inches)
KW Rating
A
240V
6.4
Allow 3/4" for overlap
of oven over all
208V 4.8
edges of cutout
Breaker Size
C
240V 30 Amps
208V
30 Amps
2" X 4" or
equiv. runners
B
H
Note: Cabinets installed adjacent to wall ovens
must have an adhesion spec of at least a 194°F
G
temperature rating.
Note: if marks, blemishes or the cutout opening is
visible above the installed oven, it may be necessary
to add wood shims under the runners and front trim
Conduit
(48-1/2"
until the marks or openings are covered.
F
long)
Note: Door handle protrudes 3" from door face.
Allow minimum of
Cabinets and drawers on adjacent 45° and 90° walls
21" for clearance
to adjacent corners,
should be placed to avoid interference with the handle.
drawers, walls, etc.
Electric wall ovens are not approved for installation
with a plug and receptacle. They must be hard wired
in accordance with installation instructions.
Installation Information: Before installing, consult
installation instructions packed with product for
current dimensional data.
Note: These ovens are not approved for stackable or
side-by-side installations.
For answers to your Monogram, GE Profile
®
GE appliance questions, visit our website at
®
ge.com or call GE Answer Center ®
800.626.2000.
Suitable
bracing
to support
runners
(must support 275 lbs.)
Cabinet
21
A – Cabinet width required
B – Minimum cabinet depth
C – Opening width
D – Opening height
E – Minimum cutout location from floor
Oven
F – Overall depth*
G – Overall height with trim
Overall height without trim
H – Overall width
*Depth including door handle is approximately 26-7/10" min. to
26-8/10" max.
or
™
service,
Recommended
junction box
C L
2 x 4 or
locations.
equivalent
Locate junction
runners
box either 5" MIN.
below cutout
floor or 48" MIN.
above cutout
floor
18"
over centerline
of cabinet
Access
from
adjacent
cabinet
required
27"
27" min.
23-5/8"
25" min. - 25-1/4" max
41-1/4" max
22"
23-5/8"
43" - 43-7/8"
42-1/8"
26-5/8"
10
A
C
D
B
Minimum
E
cutout location
Conduit
from floor
(48-1/2"
Allow minimum of
21" for clearance
to adjacent corners,
drawers, walls, etc.
All GE ranges are equipped with
an Anti-Tip device. The installation
of this device is an important,
required step in the installation
of the range.
Specification Created 5/09
Allow 3/4" for overlap
of oven over all
edges of cutout
2" X 4" or
equiv. runners
H
G
21
F
long)
Listed by
Underwriters
Laboratories
320359
Sui
bra
to sup
run
Cabinet
A – Ca
B – M
C – Op
D – Op
E – M
Oven
F – Ov
G – Ov
Ov
H – Ov
*Depth
26-8/10