GE GSD800 Owner's Manual page 21

Problem
Stained tub interior
Dishes don't dry
Dishes and flatware
not clean
Cycle and option indicator
lights stay on when cycle
is completed
Possible Causes
Detergent with
colorant was used
Low inlet water
temperature
Rinse agent dispenser
is empty
Dry cycle not complete
Inlet water temperature
is below 120°F.
Water pressure is
temporarily low
Air gap is clogged
Improper rack loading
This is normal
What To Do
Some detergents contain
•
colorant (pigment or dyes)
that will discolor the tub
interior with extended use.
Check the detergent cup
for signs of any
discoloration. If cup is
discolored, change to
detergent without any
colorant.
Make sure inlet water
•
temperature is correct.
Check the rinse agent
•
dispenser.
Make sure CYCLE ON light
•
is off, indicating the dry
cycle (if selected) is
complete.
Raise the water heater
•
temperature to 120°F.
Try the TEMP BOOST option.
•
Turn on a faucet. Is water
•
coming out more slowly
than usual? If so, wait until
pressure is normal before
using your dishwasher.
Clean the air gap.
•
Make sure large dishware
•
does not block the
detergent dispenser or the
wash arm.
Unlatch the door to turn
•
off the Cycle and Energy
Option indicator lights.
NOTE: The Cycle On light
will stay on until all cycles
are complete. Wait until
this light goes off to unlatch
the door or a cycle will be
interrupted.
21