Table of Contents
Advertisement
Verifying BFD Offload Support
You must ensure that the Session host is showing as Hardware. Use the show bfd neighbors detail to
verify the configuration of BFD Offload. Hardware BFD sessions have a LD of 1-511.
Note
Sometimes if BFD session is brought up after the registered protocol is up the session may come up in
Software. Shutdown the interface and apply the BFD config to ensure that session comes back up in
Hardware.
Switch# show bfd neighbours details
NeighAddr
34.34.34.3
Session state is UP and not using echo function.
Session Host: Hardware
OurAddr: 34.34.34.1
Handle: 295
Local Diag: 0, Demand mode: 0, Poll bit: 0
MinTxInt: 50000, MinRxInt: 50000, Multiplier: 3
Received MinRxInt: 100000, Received Multiplier: 3
Holddown (hits): 0(0), Hello (hits): 100(0)
Rx Count: 574748
Tx Count: 673965
Elapsed time watermarks: 0 0 (last: 0)
Registered protocols: ISIS CEF OSPF
Uptime: 14:22:46
Last packet: Version: 1
Cisco ME-3600X-24CX Series Switch Chassis Configuration Guide
3-2
State bit: Up
Poll bit: 0
C bit: 0
Multiplier: 3
My Discr.: 11
Min tx interval: 100000
Min Echo interval: 0 ould
LD/RD
RH/RS
1/11
Up
- Diagnostic: 0
- Demand bit: 0
- Final bit: 0
- Length: 24
- Your Discr.: 294
- Min rx interval: 100000
Chapter 3
Configuring BFD Offload
State
Int
Up
Vl3336
OL-27620-01
Advertisement
Table of Contents
