Solving Problems With The Image Or Sound - Epson PowerLite 260D User Manual

Solving Problems With the Image or
Sound
No image appears on the screen.
■ Check that the power light is green, not flashing.
If the projector doesn't turn on, the Operation Lock may be
■
enabled. Press and hold the
7 seconds to release the lock.
■ The projector may be in standby or sleep mode. If the projector
has not received any input signal for 30 minutes, it turns off the
lamp to conserve the lamp life and save energy. If the power light
is orange, press the P
■ Press the
A/V Mute
turned off temporarily.
■ If the power was switched off and then on again, wait until the
power light stops flashing and remains orange; then press the
button again.
P Power
Check the signal or
■
to make sure it is correct for the selected source. See page 56 for
more information.
■ Have messages been turned off in the
Extended menu? See page 62 for details.
■ Adjust the
Brightness
for the
Brightness Control
page 54 or page 60.
With
■ Direct Power On
Extended menu, if you unplug the projector and then plug it right
back in, you must press the P
projector. See page 58 for details.
Make sure at least one of the projector's remote receivers are
■
turned on in the Settings menu. See page 56 for details.
The attached computer may be in sleep mode or displaying a
■
black screen saver. Try pressing a key on the computer.
button on the projector for
Enter
button to turn the projector on.
Power
button to make sure the picture has not been
setting in the Signal menu
Computer Input
Display
setting on the Image menu or select
setting in the Settings menu. See
enabled in the
Operation
button to turn on the
Power
setting of the
High
setting of the
Solving Problems
85