Samsung SCO-6081R User Manual page 32

Operating Your Camera
• comm aDJ (communication adjustment) :
This function sets up the camera
communication status when controlling the
camera through an external control device.
1) When the SPECIAL menu screen is displayed,
press the Function Setup switch so that the
arrow indicates <comm aDJ>.
2) Set up the mode using the Function Setup
switch.
- PROTOCOL : Select the communication PROTOCOL. (SAMSUNG-T, SAMSUNG-E,
Pelco-D, Pelco-P, Bosch, Honeywell, Vicon, Panasonic, GE, AD)
- CAM ID : Determines the camera's identification number (between 0 and 255).
- BAUD RATE : You can select 2400/4800/9600/19200/38400/57600 bps.
- UART MODE : You can select NONE, EVEN or ODD for the parity bits.
- DISP ID : Display camera title on top left corner of the screen.
- RET PKT : Specify whether to return the same command to the controlling device when
a control command is delivered to the camera.
When protocol such as SAMSUNG-T,SAMSUNG-E,Pelco-D&Pelco-P are in using, you can use
`
J
preset95 command to activate Menu.
• LanGuaGe : You can select the menu language according to your requirements.
• reSet : Resets the camera settings to the factory defaults. Communication,
Language, Video Format and Monitor settings are not initialized.
• return : Select this to save the SPECIAL menu settings and return to the MAIN
SETUP menu.
eXit
Save the current settings and exit the MAIN SETUP menu.
32_ Operating Your Camera
COMMUNICATION SETUP
1. PROTOCOL
►
2. CAM ID
3. BAUD RATE
4. UART MODE
5. DISP ID
6. RET PKT
7. RETURN
SAMSUNG-T
.... .... .... .... 1
*
9600
8-N-1
OFF
ENABLE