Pioneer DVR-5100H Operating Instructions Manual page 80

Editing
08
Chapter Edit (Chpt Edit)
VR mode HDD
When editing VR mode DVDs or video on the HDD you
can edit individual chapters within a title, with
commands for erasing, combining and dividing. You can
also play individual chapters to check their content.
1 Select 'Chpt Edit' from the Disc Navigator menu
options.
2 Use the
title that contains the chapters you want to edit,
then press ENTER.
Chapter Edit
Original
DVD
Erase
Divide
Combine
Preview
Undo
Back
After selecting a title, thumbnails of each chapter appear
and you'll see that the Disc Navigator menu items
change to the chapter editing commands:
• Erase – Erase chapters: Select the chapter you want
to erase and press ENTER (see also notes below).
• Divide – Split a chapter into two: Select the chapter
you want to divide and press ENTER (up to a limit of
999 chapters per disc).
Divide Chapter
Original
DVD
Erase
Divide
Combine
Preview
Undo
Back
• Combine – Combine two adjacent chapters into one:
Highlight the bar divider between two adjacent
chapters and press ENTER (see also note below)
• Preview – Preview chapters: Select the chapter you
want to play; press
edit screen.
• Undo – Undo the last command (only works with VR
mode disc edits).
80
En
(cursor buttons) to select the
Title 15:00 Wed 7/10 Pr 5 LP Chapter
1 0h03m
1 2 3
4 5 6
7 8 9
Title Chapter
15:00 Wed13/12 Pr 5 LP
1 0h03m
Chapter 1
1-1 0.02.12.00
Play Pause
Divide
Exit
STOP to return to the chapter
3 Press RETURN to get back to the menu options on
the left side of the screen.
4 To return to the Disc Navigator screen, press
RETURN again, or select 'Back' from the menu
options on the left.
Note
• It may not be possible to erase chapters less than 5
seconds long.
• It may not always be possible to combine two
chapters, even though they are adjacent. If a chapter
has been divided into three, then the middle chapter
erased, it is not possible to combine the two
remaining chapters into one.
Inserting chapter markers into a title
VR mode
You can create new chapters within a title using the CHP
MARK button while playing the title or during recording.
This is useful not just for navigation of the disc content
1/1
but also for editing purposes.
1 Start playback of the title you want to create
new chapter markers in.
You can use the Play command from the Disc Navigator
menu to do this.
2 Press CHP MARK at any point where you want a
new chapter to begin.
A chapter marker icon appears on-screen briefly to
confirm a new chapter mark has been inserted:
• For greater control over the exact position of chapter
markers it can be useful to use the
and/or the slow-motion and frame advance/reverse
controls (
HDD
PAUSE
CHP
MARK
).
PAUSE button