Table of Contents
Advertisement
Depth Stop
this drill press includes a depth stop for drilling
multiple holes at the same depth.
To set the depth stop:
1.
disConneCt MAChine FroM poWer!
2.
Adjust the table height so the workpiece is
close to the work tool.
3.
Mark the side of your workpiece at the intend-
ed cutting depth (see figure 19).
Workpiece
scrap Wood
table
figure 19. depth stop mark on workpiece.
4.
secure the workpiece to the table with a
clamp or vise.
5.
place the workpiece on the table, and lower
the spindle until the tip of the bit is even with
the mark.
6.
loosen the depth stop handle, move it to the
required drilling depth, and tighten it (see
figure 20).
figure 20. setting depth stop handle.
-24-
drill Bit
Workpiece
depth
Mark
depth stop handle
7.
press the spindle start button.
8.
drill a hole into scrap stock before drilling into
any workpiece to ensure the depth has been
set correctly. if necessary, repeat Steps 2–5.
Table Positioning
the table for this drill press moves vertically
and rotates 360 degrees to accommodate larger
workpieces.
Raising/Lowering Table
1.
remove any objects from the table surface.
2.
loosen the release handles shown in figure
21).
3. Adjust the table height by rotating the height
adjustment handle (see figure 21).
height
Adjustment
handle
lock handles
figure 21. Column release and height
Adjustment handles.
Rotating Table
1.
remove all objects from the table surface.
2.
slightly loosen the lock handles (see figure
21).
3.
push the table to the desired location, and
guide the rack on the side of the column.
4.
re-tighten the lock handles.
Model G0756 (Mfg. Since 2/13)
Advertisement
Table of Contents
