Advertisement
.
Insert the flat blade screwdriver
in the slots
between the front panel & base. Pry downward
to remove the hole plugs located in the bottom
of the dryer front panel.
.
Position the dryer on top of the pedestal. Slide
the back of the dryer into the rear mounting
brackets and then slide the front of the dryer
onto the pedestal and bracket. NOTE: Two or
more people may be required.
.
.
Install the four (4) leveling legs (supplied with
the kit) fully into the pedestal.
The words "TOP FRONT" are embossed on the
top front of the pedestal. Using four (4) 8-18 x
3/8" self-tapping screws (supplied with the kit),
attach the front mounting brackets to the top
front of the pedestal. Tighten securely.
.
Insert the two (2) 10-16 x 1" screws (supplied
with the kit) through the holes in the dryer front
panel and install into the front mounting
brackets. Tighten securely
.
Using four (4) 8-18 x 3/8" self-tapping
screws
(supplied with the kit), attach the rear mounting
brackets to the rear of the pedestal. Tighten
securely.
.
10.
Reinstall the hole plugs removed in step 2.
Refer to the installation
instructions
that came
with the dryer to properly complete electrical
and venting connections.
If questions arise,
please refer to the owner's
manual that came
with the dryer for contact information.
NOTE:
The dryer/pedestal
assembly MUST be
on a solid floor and level for proper operation.
Turn the lock nut on each leveling leg up
towards the pedestal base and snug with a
wrench. Keep the leg extension
at a minimum to
prevent excessive
vibration.
Advertisement
