Advertisement
.
Attach the pedestal to the washer using the four
(4) 3/8" X 1" bolts, 3/8" lock washers and 3/8"
flat washers. DO NOT TIGHTEN
BOLTS
COMPLETELY!
8. Align the sides of the washer/dryer
with the
pedestal and tighten the bolts with a 9/16"
wrench or ratchet.
9. Carefully raise the washer/pedestal
assembly
to
the upright position. NOTE:
Because
of the
increased weight caused by the addition of
the pedestal,
two or more people may be
required.
NOTE:
Disregard
Steps 10 & 11 if the washer
has an electronic
console.
10. Remove the dispenser drawer by first sliding the
safety latch to the right, then pulling the drawer
out until it stops. Reach back into the left corner
of the drawer cavity, press down firmly on the
lock tab (left portion of the drawer) and pull out
the drawer.
11. Remove the paper backing from the foam pads
and apply to the areas shown below. NOTE:
The adhesive backing must be applied to the
rear surface of the drawer area. Replace the
dispenser drawer.
12. Refer to the installation
instructions
that came
with the washer to properly complete water,
drain and electrical connections.
NOTE:
Since
the pedestal will increase the washer height 12
inches, the minimum
standpipe
height will
increase from 24 inches to 36 inches. If
questions arise, please refer to the owner's
manual that came with the washer for contact
information.
NOTE:
The washer/pedestal
assembly
MUST
be on a solid floor and level for proper
operation.
Turn the lock nut on each leveling leg
up towards the pedestal base and snug with a
wrench. Keep the leg extension
at a minimum to
prevent excessive
vibration.
DR YER INS TALLA TION
cer Hardware
.
.
Remove the pedestal,
installation
hardware
and
instructions
from the shipping carton.
Using the pedestal shipping carton for
protection,
carefully lay the dryer on it's back
and remove the four (4) leveling legs from the
dryer base.
Advertisement
