Use a spanner to adjust the height of the adjustable feet.
o
o If your aperture has a height
feet should be fully tightened.
o If your aperture has a height of 870 m
feet should be set at a height of 50 mm.
o The appliance should be flush with the underside of the worktop
and be level. IMPORTANT: If the appliance is not level, then the
door and door seal may be affected.
o A cut out must be made in the plinth/kickboard for ventilation.
The cut out should measure 600mm in width, and between
140mm and 90mm in he
have set your appliance.
o Insert the plinth/kickboard
position to hold it in place.
o IMPORTANT: Please note that as shown in the above
drawing, an appropriately sized ventila
made in the furniture plinth/kickboard.
of 820 mm, then the adjustable
m, then the adjustable
ight, depending on the height that you
and then refit the grid in its original
tion cut MUST be
22