Cisco MDS 9216 Hardware Installation Manual page 58

Installing the Chassis in the Rack
Send documentation comments to mdsfeedback-doc@cisco.com.
If you do not find all the parts listed in
Note
of the rack mount kit, which only had the L brackets. If this is the case, you can
either install the switch in the rack with just the L brackets, or contact your
customer service representative for a current version of the rack mount kit.
Note If you purchased this product through a Cisco reseller, contact the reseller directly
for technical support. If you purchased this product directly from Cisco, contact
Cisco Technical Support at this URL:
http://www.cisco.com/warp/public/687/Directory/DirTAC.shtml.
Table 2-1
Quantity
L bracket kit
Cable guide kit
Rack mounting bracket kit
Cisco MDS 9216 Switch Hardware Installation Guide
2-8
Cisco MDS 9216 Rack-Mount Kit Checklist
Part Description
2 L brackets
12 M4 x 6mm Phillips countersunk screws
2 Cable guide
6 12-24 x 3/4-inch Phillips binder-head screws
6 10-32 x 3/4-inch Phillips binder-head screws
2 Slider rails
2 C brackets
6 12-24 x 3/4-inch Phillips binder-head screws
6 10-32 x 3/4-inch Phillips binder-head screws
4 M4 x 6mm, Phillips countersunk screws
Chapter 2 Installing the Cisco MDS 9216 Switch
Table 2-1, you may have an older version
Received
78-16165-01