Table of Contents
Advertisement
OUTPut
Subsystem Syntax
[:STATe]
Parameters
Comments
Example
[:STATe]?
Example
Chapter 4
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
The
OUTPut
subsystem enables or disables the "Trig Out" port of the HP
E1300/E1301 Mainframe or on the HP Command Module.
OUTPut
[:STATe] <
state
>
[:STATe]?
state
OUTPut[:STATe] <
>
panel of the HP E1300A/E1301A Mainframe or on the HP Command
Module.
OUTPut[:STATe] ON | 1 enables the port and OUTPut[:STATe]
disables the port.
OFF | 0
Parameter Name
Parameter Type
state
boolean
Enabling "Trig Out" Port: When enabled, a pulse is output from
the "Trig Out" port after each switchbox channel is closed. If
disabled, a pulse is not output from the "Trig Out" port after channel
closures. The output pulse is a +5V negative-going pulse.
"Trig Out" Port Shared by Switchboxes: When enabled, the "Trig
Out" port may be pulsed by any switchbox each time a scanned
channel is closed. To disable the output for a specific switchbox,
send the
OUTPut[:STATe] OFF
that switchbox.
Related Commands:
*RST Condition:
Enabling "Trig Out" Port
OUTP:STAT ON
OUTPut[:STATe]?
queries the present state of the "Trig Out" port. The
command returns 1 if the port is enabled, or 0 if disabled.
Query "Trig Out" Port Enable State
This example enables the "Trig Out" port and queries the enable state. The
OUTPut[:STATe]?
command returns 1 since the port is enabled.
OUTP:STAT ON
OUTP:STAT?
HP E1368A/69A/70A Command Reference 57
enables/disables the "Trig Out" port on the rear
Range of Values
0 | 1 | ON | OFF
or
OUTPut[:STATe] 0
,
[ROUTE:]SCAN
TRIGger:SOURce
(port disabled)
OUTPut[:STATe] OFF
Enables "Trig Out" port to output
pulse after each scanned channel is
closed.
Enables "Trig Out" port for pulse
output.
Query port enable state.
Default Value
OFF | 0
command for
Advertisement
Table of Contents
