Honeywell HRHD 410 User Manual page 81

Configuration
The factory default Port settings are:
Caution
To save your changes and return to the Network Setup screen, highlight OK and then
press
LAN — DHCP
Selecting DHCP from the Type box on the LAN Setup screen, and highlighting OK
reads the current IP Address of the DVR configured by the DHCP (Dynamic Host
Configuration Protocol) network.
Rev 3.03
Remote Admin:
Remote Watch:
Remote Search:
Remote Callback:
Note The system restarts automatically after changing the port
settings.
Note Do NOT use the same port number for two different programs,
otherwise, the DVR cannot be connected with a PC running RAS.
When changing the port settings, you must change the port
settings on the PC running RAS as well. Refer to the
Administration System (RAS) User Guide
. Select Cancel to exit the screen without saving the changes.
8200
8016
10019
8201
for details.
63
Remote
Document 900.0315
02/07