Example Of Macro Programming; Using A Programmed Macro Key - Honeywell ADEMCO VISTA-10P User Manual

Macro Key Program Macro Key Programming & Usage
Macro Key Program Macro Key Program
The keypad beeps to acknowledge your input and
displays the command you entered (followed by "F").
3. Enter the next command, followed by press/holding
the "D" key for at least two seconds. The keypad
beeps and displays the keystrokes entered so far.
4. Repeat until all the desired commands (up to 16
characters including the "F"s) have been entered.
Be sure to check your keystrokes before continuing.
If you made a mistake, you must start over.
5. To exit, press/hold the "D" key for at least two
seconds. The display returns to system status and
indicates system is ready.

Example of Macro Programming

Example of Macro Programming Example of Macro Programming Example of Macro Programming
Suppose you want to (1) bypass the two upstairs window zones, then (2) turn on an
exterior light, and then (3) arm the security system in the AWAY mode. The
procedures in the table that follows show you how you would program this macro:
Function
1. Bypass zones 02 &
03
2. Insert terminator.
3. Turn light on
(device 01).
4. Insert terminator.
5. Arm system AWAY
6. Insert terminator.
7. Exit Macro mode

Using a Programmed Macro Key

Using a Programmed Macro Key Using a Programmed Macro Key Using a Programmed Macro Key
DISARMED
READY TO ARM
ENTER USER CODE
* * * *
– 26 –
ming & Usage
ming & Usage ming & Usage
Keystrokes Required
Press BYPASS [6] key, then
2-digit zone number 02, then
terminator "D"' then [6], then 2-digit
zone number 03, then terminator "D".
Press the "D" key for at least 2 seconds.
Press [#] and 7 keys for "device ON",
and [01] key for selecting device 1.
Press the "D" key for at least 2 seconds.
Press AWAY [2] key.
Press the "D" key for at least 2 seconds.
Press the "D" key again.
1. Press the Macro key programmed for the desired
series of commands for at least 2 seconds. The "Enter
User Code" prompt appears. The prompt remains
displayed for up to 30 seconds.
2. Enter your 4-digit security code.
The programmed macro sequence begins
automatically after the user code is entered.
(cont.) (cont.)
(cont.) (cont.)
Typical Macro Alpha Display:
MACRO PGM
6 0 2 F 0 3 F 7 0 1 F 2 F
#
Keypad Display
6 0 2 F 6 0 3
6 0 2 F 6 0 3 F
6 0 2 F 6 0 3 F 7 0 1 F
#
6 0 2 F 6 0 3 F 7 0 1 F
#
6 0 2 F 6 0 3 F 7 0 1 F 2
#
6 0 2 F 6 0 3 F 7 0 1 F 2 F
#