Dell Precision M60 Service Manual page 13

CAUTION: Before performing the following procedures, read the safety instructions in your System Information Guide.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by touching an unpainted metal surface on the computer.
1. Follow the instructions in "Preparing to Work Inside the
2. Remove the central control
3. Remove the display assembly.
4. Remove the display bezel.
5. Remove the nine M2 x 3-mm screws from the display panel.
6. Lift the display panel, and rotate the display panel out of the top cover.
7. Remove the yellow tape from the top display connector.
8. Press in the tabs on both sides of the top display-cable connector, and pull the display cable connector away from the top flex-cable connector.
1 top flex-cable connector
2 top display-cable
connector
3 tabs
9. Use the pull-tab to disconnect the bottom flex-cable connector from the inverter connector.
1 top flex-cable connector
2 top display-cable
Computer."
cover.