Cisco 5512-X Installation Instructions Manual page 8

7
Attach the Outer Slide Rail to
Round and Square Hole Racks
Align the front of one of the outer slide rails with the rack
upright, push it forward, and click it into place. Align the rear
of the outer slide rail with the rack upright, pull the release tab,
push the slide rail toward the rack, release the tab, and click it
into place.
For racks shorter than 24 inches in depth, remove the
Note
rear bracket with a Phillips head screwdriver, pull the
release tab, and adjust the slide rail to the appropriate
length for the rack.
Secure the other outer slide rail to the rack by repeating the
previous steps.
Go to the "Install the Chassis" section on page 10.
8
Front of
Rack
Rear of
Rack
Rear of
Bracket