Installation - Fujitsu MB88121 SERIES User Manual

SK-91F467-FLEXRAY V1.1

Installation

2 Installation
Remove the board carefully from the shipping carton.
First check if there are any damages before power on the starter kit.
To supply the starter kit, use the delivered In-Plug AC-DC Adapter (UPA 2000). Select the
AC plug adapter suitable for your country power sockets
Figure 2-1: AC plug adapter
and insert this adapter into the connection terminal on the AC-DC adapter.
Figure 2-2: AC plug adapter selection
Check the selected output DC voltage of the AC-DC In-Plug adapter at the voltage selection
key. It should be 9V! Change the output voltage only in a powered-down condition!
Figure 2-3: DC voltage selection
Select the low voltage adapter suitable to the power connector X5 at the SK-91F467-
FLEXRAY and plug it to the connecting socket in the right orientation (+ connected to shield
and GND connected to centre pin).
Figure 2-4: Low voltage adapter selection
Now connect the DC low voltage adapter to the Starter kit and plug in the In-Plug Power
Supply to a power socket. The SK-91F467-FLEXRAY can be turned on with the on board
power switch S8 (or S9).
FMEMCU-UG-910017-11 - 12 - © Fujitsu Microelectronics Europe GmbH