Using The Remote Control - ViewSonic PJ650 Service Manual

6-4 Before Replacing the LCD / Lens Prism
You should not replace separately the parts of the liquid crystal LCD / Lens Prism because it works properly
only when used together. Therefore, regarding these parts, you can either replace part , LCD / Lens Prism
assembly, or send the whole unit LCD / Lens Prism assembly back to SUPPLIER, where we will replace the
malfunctioning part, recondition the device and send it back to you.
DISTRIBUTOR

6-5 Using the Remote Control

Precautions to observe in regards to the batteries
Always handle the batteries with care and use them only as directed. Improper use may result in battery
cracking or leakage, which could result in fire, injury and/or pollution of the surrounding environment.
• Keep the battery away from children and pets.
• Be sure to use only the batteries specified for use with the remote control. Do not mix new batteries with
used ones.
• When inserting batteries, verify that the plus and minus terminals are aligned correctly (as indicated in the
remote control).
• When you dispose the battery, you should obey the law in the relative area or country.
Putting Batteries
1. Remove the battery cover.
Slide back and remove the cover in the direction of the arrow.
2. Insert the batteries.
Align and insert the two AA batteries (that came with the projector)
according to their plus and minus terminals (as indicated in the remote
control).
3. Close the battery cover.
Replace the cover in the direction of the arrow and snap it back into place.
ViewSonic Corporation
PJ650
Do not disassemble the unit
because replacement of separate
parts is not possible.
Return
CAUTION
18
SUPPLIER
Replacement of G Panel
G Panel
Reconditioning
PJ650